China OEM Pulley Driven Generator Factory - Overrunning AlternatorPulley F-587281 – RNA

The OAP pulley can be divided into outer ring and inner ring. If the inner ring speed (i.e. generator rotor speed) exceeds the outer ring speed during operation, the pulley will slip immediately, and the inner ring and outer ring will be separated. When the engine changes from high speed to low speed, due to the function of one-way clutch, the outer ring of the overrunning pulley moves to low speed synchronously, and the speed of the inner ring still runs at high speed by inertia, that is, higher than the speed of the outer ring. At this time, there is a difference in the speed between the inside and outside, and the pulley is in the slip state. Pansun’s products can form a short buffer state between the transmission belt and the one-way pulley to reduce the jitter caused by the impact of the difference (which is extremely unfavorable to the generator rotor and rotating shaft). When the engine accelerates, the outer ring gradually reaches the same speed as the inner ring before it can return to the combined state. In this way, it can protect the emergency stop torsional vibration of the generator and the transmission belt under the emergency stop state of the engine. The generator can continue to rotate inertia and stop slowly under the protection of exceeding the pulley, which can effectively prolong the service life of the transmission belt, Further promote the smooth operation of the engine and even reduce the emission of carbon monoxide.